WPS settings for D-Link DAP-1320 Wi-Fi Range Extender

Setup your new D-Link DAP-1320 Wi-Fi Range Extender using WPS setup and you will not need to access any setup page of your extender device. WPS setup is used so that you can configure your device even without using setup CD. Later you can make http //dlinkap.local access and then you can change settings for your device very easily.

WPS Setup for D-Link DAP-1320 Wi-Fi Range Extender Device

1.     Plug in the power supply for your dlink wifi extender device.

2.     Wait for few seconds because this will help your devices to get power supply accurately. Change the admin password for your Dlink wifi router devices.

3.     Press WPS button from your router device that you are already using at your network.

4.     After that press WPS button from D-Link DAP-1320 Wi-Fi Range Extender device.

5.     When you press WPS button from both of your device, your devices will added to your network.

Your D-Link DAP-1320 Wi-Fi Range Extender device and router device are now connected to each other and they will easily extend your wifi network. When you need to change further settings for your device, you can access http //dlinkap. local page of your device and make changes for your device settings.

What if WPS Setup if Fail for Dlink Device?

If you find that your WPS configurations are not working then you can follow same steps again and again. You can also setup your new device manually and for that you can need setup CD. with each new device you will receive a new setup CD, this setup CD can be used to configure and setup a new device. you can request dlink support team to provide you remote help and they will help you to configure your device easily.