why assign the IP address to switch

As we know that the most numerous devices installed on the corporate network infrastructure, among this numerous device switch are one of them. www 192.168 o 1.1 admin It is also very fun and challenging to configure them. It is also very important to know how switch normally boots and load an operating system. Get the information regarding the wireless setting for the netgear wn2000rpt wifi extender.

Switch Boot Sequence (2.1.1.1)

1- At First, the switch loads a power-on-self-test program stored in ROM. After that, you have to POST checks the CPU subsystem.

2- Then the switch loads the boot loader software.

3- The boot loader performs low-level CPU initialization.

4- With the help of bootloader initializes you will be able to flash file system on the system board.

5- At last the bootloader locates and then automatically loads a default IOS operating system software image into memory after that the hand's control of the switch over to the IOS.

Recovering from a System Crash (2.1.1.2)

1- At first you have to Connect a console cable from the PC to the switch console port.

2- Then remove the Switch Power Cord.

3- Then you have to reconnect the power cord to the switch. And then press the switch for 15 seconds and then hold down the Mode button while the System LED is still flashing green.

4- If the flash is not blinking in green color then continuously press the switch.

5- The prompt appears in the terminal emulation software on the PC.

With the help of Boot Loader, you will be able to format the flash file system, reinstall the operating system software, and recover from a lost or forgotten password. There are several status LED indicator lights in Cisco Catalyst switches. A different model of switches has a different set of LED light.